Pulled the sidemarkers and trim from the headlights out. Then removed the clear lenses.

Left with a wide-eyed looking headlight.

Clipped the angel eyes to the headlight.

Make sure it is hella flush approved.

(Not pictured) pulled the wiring through the rubber boot in the back of the headlight housing and wired up accordingly.

Bam.

Both sides wired up.

All the lenses and trim buttoned back up and ready to go. My driver-side headlight was shattered where Austin and I collided... so this was a good time to epoxy it back together.

My point-and-shoot does these things ZERO justice. They look awesome, and they are SUPER bright.

Alex's RAD pic through the caution tape from Turner shows them way better.








