Page 1 of 1

stupid mouse....

Posted: Mon Mar 18, 2013 3:04 pm
by struka
ate my wires.
Anyone knows what these are so I can look them up and wire them back up? Car runs fine without it seems since I just found it yesterday and I have been driving it around.

Image

Re: stupid mouse....

Posted: Mon Mar 18, 2013 5:05 pm
by FooSchnickens
Grey connector looks like a temp sensor, but I cannot into 240 wiring so I could be totally wrong.

Re: stupid mouse....

Posted: Mon Mar 18, 2013 5:24 pm
by struka
found out one wire connector is temp, two wire is knock sensor.

I need to look at it some more. Since one is a knock sensor, I would figure the car would be acting up but seems to be doing fine. I wonder if that has something to do with the Enthlapy ECU that I have.

Re: stupid mouse....

Posted: Mon Mar 18, 2013 6:57 pm
by Zenkis14
struka wrote:found out one wire connector is temp, two wire is knock sensor.

I need to look at it some more. Since one is a knock sensor, I would figure the car would be acting up but seems to be doing fine. I wonder if that has something to do with the Enthlapy ECU that I have.
If this is an SR or KA, those should both be temp sensors, one sends signal to ECU the other sends signal to gauge on dash. The knock sensor is located underneath the intake manifold directly on the block. ;)

Re: stupid mouse....

Posted: Tue Mar 19, 2013 8:53 am
by struka
found this:

http://forums.nicoclub.com/1991-1994-24 ... 53121.html

So looks like it is the knock and the temp gauge for the cluster.

Thanks!

Re: stupid mouse....

Posted: Wed Mar 20, 2013 10:41 am
by icantdrift
Yeah, those. Why not just rewire the plugs? Doesn't matter what they are, the wire colors match up :wink:

Re: stupid mouse....

Posted: Wed Mar 20, 2013 11:05 am
by struka
that's what i am going to do.

one plug has wire chewed up all the way down to the base so it will be hard to solder.