Slew of S13 stuff for sale
Moderators: charlie, darkducati, CodyW, Rhoad Racing
Slew of S13 stuff for sale
Will consider trades for '87 FC RX-7 parts.
Pictures of everything here
'89 S13 Hatchback SE Rolling Shell/Parts car
$600
192k Miles
Strait frame
Quarter window and tail lights have common leak
Small dent above rear bumper and large one in the passanger quarter panal and door
DOHC P/S Lines
No A/C stuff
Rear 5-lug Hubs
180SX VLSD Rear Axle
Tien Tieirods w/ Kazama adjustible tie-rod ends
Some Enkie Wheels that came with my RX-7, the Bullitt Wheels on the back of the car are not included.
180SX 7500RPM redline tach
Radio Harness has a Mitsubishi plug on it.
Fuel pump is hardwired with 12GA wire
Full Body harness in car still
KA24E M/T ECU
Replaced Brake Master Cylinder a little over 2years ago
Replaced Clutch Slave and Master Cylinder last year
No carpet and no interior past the b-pillars
Driveshaft
SR20DET Red top w/ late style head
5spd Trans
S13 wired engine harness
$2200
The Good
- Approx 60k Miles
- Cold compression test done in December about 6k ago and 150~152 across the board
- Always used Mobile 1 and OEM filters
- Runs strong and pulls hard
- Exedy Stage 1 Clutch
- Split-fire coil packs in-place of the OEM ones
- Purchased by me from Jarco
The Bad
- Occasionally the car feels bogged at low rpm high throttle (below 3krpms)
- Rear trans seal leaks (easy to replace at the moment)
- Doesn't have an A/C Compressor and bracket
Greddy 20x9x2.75 FMIC
Piping
HKS SSQ Version 1 BOV
Couplers
$400 OBO
The Bad
- 2 Dings in the cold side upper IC pipe
- FMIC is slightly twisted but can be fixed easily with a board with holes cut in it for the mounting brackets to go through
Koyo alluminum radiator
Flex-a-lite slim fans
Spal fan controller w/ temp sensor
$350 OBO
"3 Megan Racing Downpipe
"3 Megan Racing Testpipe
"3 4G Performance catback w/ N1 muffler
$300 OBO
Pumpkin with open diff and 6 bolt axles
$60 OBO
Walbro 255lhp High pressure
$80
Pictures of everything here
'89 S13 Hatchback SE Rolling Shell/Parts car
$600
192k Miles
Strait frame
Quarter window and tail lights have common leak
Small dent above rear bumper and large one in the passanger quarter panal and door
DOHC P/S Lines
No A/C stuff
Rear 5-lug Hubs
180SX VLSD Rear Axle
Tien Tieirods w/ Kazama adjustible tie-rod ends
Some Enkie Wheels that came with my RX-7, the Bullitt Wheels on the back of the car are not included.
180SX 7500RPM redline tach
Radio Harness has a Mitsubishi plug on it.
Fuel pump is hardwired with 12GA wire
Full Body harness in car still
KA24E M/T ECU
Replaced Brake Master Cylinder a little over 2years ago
Replaced Clutch Slave and Master Cylinder last year
No carpet and no interior past the b-pillars
Driveshaft
SR20DET Red top w/ late style head
5spd Trans
S13 wired engine harness
$2200
The Good
- Approx 60k Miles
- Cold compression test done in December about 6k ago and 150~152 across the board
- Always used Mobile 1 and OEM filters
- Runs strong and pulls hard
- Exedy Stage 1 Clutch
- Split-fire coil packs in-place of the OEM ones
- Purchased by me from Jarco
The Bad
- Occasionally the car feels bogged at low rpm high throttle (below 3krpms)
- Rear trans seal leaks (easy to replace at the moment)
- Doesn't have an A/C Compressor and bracket
Greddy 20x9x2.75 FMIC
Piping
HKS SSQ Version 1 BOV
Couplers
$400 OBO
The Bad
- 2 Dings in the cold side upper IC pipe
- FMIC is slightly twisted but can be fixed easily with a board with holes cut in it for the mounting brackets to go through
Koyo alluminum radiator
Flex-a-lite slim fans
Spal fan controller w/ temp sensor
$350 OBO
"3 Megan Racing Downpipe
"3 Megan Racing Testpipe
"3 4G Performance catback w/ N1 muffler
$300 OBO
Pumpkin with open diff and 6 bolt axles
$60 OBO
Walbro 255lhp High pressure
$80
- ChokingVictim
- Ripe Meat
- Posts: 117
- Joined: Thu Jun 22, 2006 11:30 pm
- Location: ST. LOUIS
- ChokingVictim
- Ripe Meat
- Posts: 117
- Joined: Thu Jun 22, 2006 11:30 pm
- Location: ST. LOUIS
- POOPscandal
- Taco Bar Extraordinaire
- Posts: 4360
- Joined: Tue Dec 07, 2004 12:59 am
- Location: !black emperor
i used to own that rx7.BlackMage wrote:Turbo II engine harness (mines hacked to shit)
OEM front bumper
CF Hood w/ scoop
I just got the car and really haven't gone through it to see what all it needs. Trying to get money FOERST so I can pay off the friend I got the car from.
have fun. i do miss my hks and falken stickers at the top of the hatch. oh and if you want the center caps for the enkeis i got those too.
Superb Tough Highest Performer Driven to Lifestyles Unimaginable
PHOTOBLARG! NEW EXCITING BLARG!
"thanks man, I didn't do it, but I'm a fan of apple penis" - internet
PHOTOBLARG! NEW EXCITING BLARG!
"thanks man, I didn't do it, but I'm a fan of apple penis" - internet
- darkducati
- Purple Drank
- Posts: 2496
- Joined: Sat Apr 24, 2004 10:13 pm
- Location: Setting the world on fire, one upshift at a time.
-
- Fresh Meat
- Posts: 68
- Joined: Sun Dec 23, 2007 2:27 pm
- Location: Suwanee
I somehow managed to break my other account somehow so if anyones sent me a PM at any time about anything please resend them to this account.
Also the radiator/fan set no longer has the fan controller or temp sensor.
I'll let everything but the pumpkin/axles and wally 255 go for $3100 if you buy it all at once
Engine set lowered to $2000
Also the radiator/fan set no longer has the fan controller or temp sensor.
I'll let everything but the pumpkin/axles and wally 255 go for $3100 if you buy it all at once
Engine set lowered to $2000
-
- Fresh Meat
- Posts: 68
- Joined: Sun Dec 23, 2007 2:27 pm
- Location: Suwanee
-
- Fresh Meat
- Posts: 68
- Joined: Sun Dec 23, 2007 2:27 pm
- Location: Suwanee
-
- Fresh Meat
- Posts: 68
- Joined: Sun Dec 23, 2007 2:27 pm
- Location: Suwanee