01' GC RS Dyno results

revel · Post by **revel** » Wed Jan 19, 2005 7:12 pm

well the GC was dynoed at TopSpeed. and the results are in

WHP=138.4
WTQ=158.3

and showed a pretty even 50/50 split between front and rear. i am going to get the dyno pic up soon so there are no doubts. also andy, if possible, could you help me get the video of my dyno runs webworthy. need them to help sell my headers, cat, and catback.

darkducati · Post by **darkducati** » Wed Jan 19, 2005 7:46 pm

Man those are GOOD numbers. The SCC project car layed down about 100 or a little less stock. That's nearly 40WHP over stock. That's a serious gain for an N/A 2.5. I give it two snaps up in a circle!

Prince Nismo · Post by **Prince Nismo** » Wed Jan 19, 2005 9:19 pm

what mods are you running for the dyno... those are frickin awesome numbers much love .jm.

revel · Post by **revel** » Thu Jan 20, 2005 12:40 am

Cobb CAI (made by Gansflow)
Brullen Equal Length Headers
Brullen Hi-Flow Cat
Brullen Single Tip 2.25" Catback

thats it for power mods. looking into fuel management or possibly a whole stand-alone since there are still no reflash options for the GC RS. but yeah i was pretty surprised by the numbers. i was expecting to be around 120whp and 130wtq and more of a 60/40 front to rear split.
and of course i got to hear my car hit around 80mph in, i think, 3rd gear. flippin wicked loud. my guts told me the same thing during each run.

CodyW · Post by **CodyW** » Thu Jan 20, 2005 2:21 am

sweet, that is real nice!

Post by **andysapp** » Thu Jan 20, 2005 6:34 pm

Hellz yeah, Tyler!!
That's rad!! I had no idea you were going up there to do that! Sweet #'s!

Yes I can help you get the vidz online, NP. I still have to get your tray slides up there too!

revel · Post by **revel** » Thu Jan 20, 2005 7:22 pm

ah yes. the tray drift session. need to get some of those coke trays and get another session or two in. also found out that my rear sway bar was set at the lowest setting, so going to set it much stiffer. adjusted my TPS so i can punch it in FOERST, rather than waiting for second to floor it. seem to have much better throttle response now. not to mention while i was warming the car for its dyno runs, i drove around for a minute and discovered that all i need to do is get up to around 45mph-begin turning wheel-let off accelerator-lightly tap brakes once or twice-then the back end gets loose and the GC initiatesw drift quite easily. now i just need to learn how to control the angle and keep the car sideways.

andy you down for FF-tray/AWD practice sessions sometime?

CodyW · Post by **CodyW** » Thu Jan 20, 2005 9:23 pm

i'll bring the mx3

charlie · Post by **charlie** » Fri Jan 21, 2005 2:27 pm

DTCdrift · Post by **DTCdrift** » Fri Jan 21, 2005 2:37 pm

good #'s

u use trays to drift??? how are you controlling it?

revel · Post by **revel** » Sun Jan 23, 2005 5:46 pm

i use trays on a FWD, not my suby. just put em under the rear tires, pull ebrake, then go nuts.